Ski Boots

Atomic Hawks Ultra XTD 130 BOA GripWalk Review: A Low-Volume Hybrid Touring Boot

A close look at the Atomic Hawks Ultra XTD 130 BOA GripWalk, a narrow, low volume hybrid touring boot with a moldable Mimic liner, BOA lower closure, and a true 50/50 build.

Two low volume hybrid touring ski boots standing on a matte concrete surface

Introduction

The Atomic Hawks Ultra XTD 130 BOA GripWalk may have one of the longest names in ski boots, and the spec sheet behind it is just as busy. It is a 130 flex, low volume hybrid touring boot built around a True Flex polyurethane shell, a BOA closure on the lower cuff, a full GripWalk sole, and tech fittings for pin bindings.

That combination places it squarely in the crossover category: light enough to climb with, stout enough to spend a full day riding lifts. The more interesting questions are where its real limits sit and whether the fit suits your foot.

Who the Atomic Hawks Ultra XTD 130 BOA GripWalk Is For

This boot is aimed at skiers who want a single pair of boots for both lift served days and human powered days, and who have a narrow, low volume foot. Atomic lists a 98 mm last, and the shell itself is marked 94 mm, which makes it a genuinely narrow fit.

In the size tested, the boot sole length is 282 mm, and it is worth noting that this is a small platform. It also weighs in around 1,800 g, which keeps it competitive with other boots in the hybrid touring zone.

Ski tourer skinning uphill on a dawn ridge line with snow covered peaks behind

The profile points toward skiers with an off-piste mindset: people who spend most of their season in softer snow, tour occasionally, and value a tight, precise connection over a roomy, immediately comfortable fit. If your foot is wide or high volume, this is not the boot to start with.

Shell, Liner, and Fit

The shell uses True Flex polyurethane, a material chosen so the flex stays consistent regardless of temperature. The construction relies on ridges and varying wall thickness, with a reinforced section at the rear that Atomic calls the energy backbone. There is also a friction pivot at the upper cuff, which is common on touring boots and makes cuff alignment slightly more involved, though the shell is moldable enough to work around that.

The liner is the Mimic Platinum, a dense, heat moldable design with an aggressively articulated heel pocket and four pull tabs. Those extra tabs exist because molding matters so much here: the fit is so tight to begin with that the liner has to be positioned precisely before it is heated.

Skier floating through deep powder snow between sparse trees

That liner is not optional to mold. Out of the box, this boot simply does not fit most feet. After molding, the liner becomes thin but supportive and ergonomic, which is what makes the tight shell usable. The practical rule is blunt: if this boot feels comfortable before molding, it is probably too big. Because the liner is so dense, it also should not pack out much, so day one and day one hundred should feel similar.

Main Strengths: Touring Comfort and Powder Performance

The walk mode is the most powerful one in Atomic’s lineup, with roughly 54 degrees of articulation in the upper cuff. That translates into a comfortable, natural stride on the uphill, and the walk lever and buckles are easy to operate with gloves or mittens on, even in cold, windy conditions. The BOA dial pops open in one motion at the bottom of a descent.

On the downhill side, the story is a tight, locked-in fit that sends almost every movement straight to the ski. In low angle terrain, wind affected soft snow, and deep cat skiing powder, the boot felt composed and precise, with no obvious limitations. A full lift served day of roughly 25,000 to 30,000 vertical feet also stayed comfortable, which says a lot for a boot this light.

Close view of a ski edge carving a high angle turn on firm groomed snow

It is a true 50/50 boot in the sense that it can genuinely do both jobs, provided you accept that its ceiling on hard snow sits below a dedicated alpine boot. For soft snow and off-piste terrain, the fit and the low weight do most of the work for you.

BOA Closure, Walk Mode, and Hardware

The BOA system on the lower cuff is the most talked about feature here, and the benefits outweigh the drawbacks. One click is a very small adjustment, which makes it easy to fine tune tension on the fly, whether that is a single click mid ascent or one or two clicks tighter at the top of each lift. The main trade-off is that a single cable pulls both lower zones with roughly the same pressure, so you cannot tension the instep area independently. Skiers with a very sensitive or high instep may notice that.

Up top there are two touring style buckles that lock forward, plus trapdoor keepers that hold the buckle ladder in place when you release tension. The 50 mm power strap uses a switch closure: flip it open and the strap slides free, flip it closed and it ratchets down. That is a genuinely useful detail when your hands are cold and you are trying to get boots off at the end of the day.

Boot fitting bench with ski boot liner warming equipment and tools

Other details worth knowing: forward lean comes set at 15 degrees and can be adjusted to 13 or 17, though moving it to 17 at home is physically difficult and much easier with a vise and the right tool. The rear walk mechanism can be swapped for a fixed bar if you plan an extended stretch of lift served skiing only. The sole is a full GripWalk design with a rubbery tread through the middle of the foot and no replaceable alpine toe and heel, and there are tech fittings for true pin bindings. After hard use, including shell damage from ski edges, the BOA closure never released or showed signs of failure.

Firmer Snow and Carving: Where the Compromises Show

On firm snow with higher edge angles, the difference between this boot and a dedicated 130 flex alpine boot becomes clear. The Hawks Ultra XTD does not offer the same support at the very top of the cuff, and you can feel the shell bend and twist slightly when you push a hard carving turn.

GripWalk soles also give a marginally less precise connection at the toe piece on firm, icy surfaces, which shows up as a small loss of power transfer. That said, in softer packed powder and warmer conditions, the gap largely disappears. The honest summary is that the boot is excellent in soft snow, very good in mixed conditions, and simply not built to be a hard snow carving weapon.

Things to Consider Before Buying

The liner must be heat molded for the boot to work at all, which means this is not a purchase to make online without support. The last is narrow and the volume is low, so a wide or high volume foot will not get along with it regardless of molding. Forward lean changes beyond the stock 15 degrees are awkward to do at home.

At around $950, the boot costs less than buying a dedicated alpine pair plus a dedicated touring pair, but you are trading away firm snow precision to get that value. Skiers who spend most of their season on hard groomed runs and rarely tour will be better served elsewhere.

Buying Advice for the Atomic Hawks Ultra XTD 130 BOA GripWalk

Start with a boot fitter. Try the boot on with an open mind, because the initial fit will feel extremely tight and that is expected rather than a sign of the wrong size. Plan for liner molding as part of the purchase, not an optional extra, and expect the fit to change dramatically once the Mimic Platinum liner has been heated and set.

If you have a narrow, low volume foot, split your season between soft snow and touring, and want one boot to cover both, the value here is strong. If you chase firm snow carving or have a wider foot, look at a different boot in the crossover category or a dedicated alpine model.

Conclusion

The Atomic Hawks Ultra XTD 130 BOA GripWalk is a specialist, and it is honest about that. It delivers a remarkably precise, locked-in fit, comfortable touring performance, and confident soft snow handling, while giving up a little top-end support on firm snow. For the right foot and the right ski day, that trade is an easy one to accept.

Product link

View more details for Atomic Hawks Ultra XTD 130 BOA GripWalk

This product is mentioned in the review. Check the specifications, options, and compatibility before buying.

View more details for Atomic Hawks Ultra XTD 130 BOA GripWalk

Further reading

Related Reviews

Six alpine ski boots and a separate low-volume liner arranged on a concrete surface

Ski Boots

2027 Ski Boot Roundup: Six 130-Flex Boots Worth Knowing

Six 130-flex ski boots for 2027, plus a low-volume liner upgrade, compared on weight, fit, flex feel, and ease of use.

10/14/2026
Armada AR One three-piece ski boot standing on a matte concrete surface

Ski Boots

Armada AR One Ski Boot Review: A Three-Piece Cabrio That Finally Gets It Right

Armada's first ski boot blends three-piece Cabrio design with Atomic engineering, a heat-moldable shell, and a 100mm last that fits better than any Cabrio before it.

10/15/2026
Armada AR1 ski boot with cabrio tongue and cable buckle standing on concrete

Ski Boots

Armada AR1 Ski Boot Review: A Cabrio and Overlap Hybrid for Park and Freeride Skiers

Armada's first ski boot pairs a three-piece cabrio shell with overlap-style buckles and a cable-driven slingshot buckle. Here is where it shines, and what to weigh before buying.

10/14/2026