CountyComm Armorers Hammer Review: A Six-Headed Take on the Small Hammer

Introduction

Small hammers have a quiet following among people who work on firearms, electronics, and anything else where a full-size hammer is simply too much tool. The CountyComm Armorers Hammer takes that niche seriously with an unusual idea: instead of the familiar two-face hammer, it carries six swappable heads arranged around a central body. At roughly $15, it is an affordable experiment in tool design that mostly works.

The Six-Head Design

The hammer’s defining feature is its six heads, which unscrew individually. A locking washer sits behind each head to keep it tight during use, and the threading means you can potentially swap in other components if you can match the thread. The aluminum-headed version is strongly magnetic, so heads stay put until you decide otherwise. CountyComm sells this design in both nylon and aluminum head versions.

The aluminum heads are worth a closer look. Because you are effectively striking aluminum on aluminum, they behave differently from nylon faces on the same material, which is the more forgiving pairing for non-marring work. Durability of the soft aluminum faces over the long term is an open question, so treat them as consumable light-duty faces rather than heavy striking surfaces.

Who It Works For

This hammer makes the most sense for small persuasion needs: electronics work, precision assemblies, and other light-duty tasks where control matters more than force. It is a natural fit for armorer-style work, though anyone who occasionally needs a gentle, controlled tap will find uses for it.

One fair concern is clearance. Six heads are bulkier than two, and in recessed areas the extra faces can get in the way. In practice there is enough room for most tasks, and if one head blocks access, you can remove it or reach for a more conventional hammer. The trade-off is rarely as annoying as it sounds on paper.

The Small Hammer Family

The Armorers Hammer sits in a broader family of compact hammers that reward a closer look. Classic small ball peen hammers, like a well-loved 2 oz blue ball peen, remain favorites for their balance and lack of vibration. Compact dead blow hammers deliver weight without recoil and are handy for seating parts without marring them.

The traditional two-face hammer is an old design, arguably descended from a lashed stone, and it has changed remarkably little. The six-head concept is one of the more genuinely fresh takes on it in a while, which is part of why it earns attention.

Things to Consider Before Buying

The head arrangement dictates the handle too. With six striking directions, there is no grain orientation to worry about, and the handle has no traditional alignment. The aluminum version has become hard to find, so check availability before committing; the nylon version is easier to source and may actually suit most buyers better, since nylon faces are more forgiving on softer materials.

Buying Advice

For most people, the nylon-headed version is the safer pick, especially for non-marring work on bolts and finished parts. If you can find the aluminum version, it is an interesting variant, but expect the faces to show wear faster. Either way, the low price makes this a low-risk addition to a precision workbench.

Conclusion

The CountyComm Armorers Hammer is a clever, inexpensive twist on a tool design that has barely changed in centuries. It will not replace a proper dead blow or a fine ball peen for heavier work, but for light, controlled persuasion on electronics and precision assemblies, six heads beat two more often than you would expect.