Grow Lights
Bloom Plus XP 4000 Review: A Lean LM301H Grow Light With Even Coverage
A thin, light panel built around LM301H diodes that delivers strong PPFD readings, low heat output, and straightforward installation.
Introduction
The Bloom Plus XP 4000 arrived as a replacement panel, and it set out to prove what LM301H-based lights can do. It did not disappoint. From the unboxing onward, this light felt like a well-sorted fixture: clean panels, crisp-looking LEDs, and even brightness across the canopy. Here is how it performed in day-to-day use.
Design and Build Quality
Unboxing revealed clean panels with LEDs that look crisp, which is exactly what authentic LM301H diodes should look like. A count of the diodes on this light came to 784 regular LEDs plus 24 infrared LEDs.

Flipping the panel over shows a lot of wiring, which can look excessive at first. It raised some initial concern about heat, but in practice that worry did not hold up. The power lines use a unique twist-to-connect design that secures the connection and helps prevent water from getting in.
The light runs on Moso drivers dedicated to LED lighting, with two of them providing up to 200 watts each. That puts the fixture’s maximum output at 400 watts. The dimmer adjusts from zero to 100 percent, with zero being completely off. Included hardware covers two rope clip hangers and two metal wires.
Installation and Hanging
The panel itself is super thin, and because of that it is relatively light. That makes installation easier than with bulkier fixtures, and it is simple to hang the XP 4000 even while another light is still in place.

In practice, four rope clip hangers were used instead of the two included, following a proper hanging setup. The low weight and slim profile make that adjustment painless.
Light Output and Coverage
Once installed at 18 inches, the outside reading measured around 900 PPFD right away, which matched the 12-inch center reading on the light it replaced. That is a serious jump in usable coverage.
The center reading at 18 inches came in slightly over 1,000 PPFD. Because the center and edges are so close together, the light is distributed evenly across the footprint. That evenness comes down to LED spacing, which is more compressed around the edges of the panel.

Heat Output and Everyday Use
Of all the lights used before it, this one emits the least amount of heat. That is a genuine advantage in summer, keeping the grow space cooler without extra ventilation work.
In winter, low heat output is less of a benefit, since some growers rely on fixture warmth as part of the environment. That is the one trade-off worth weighing. It also explains why the excess power cabling above the panel turned out to be less of a concern than it first appeared.

Buying Advice
If your grow space struggles with heat, or you want strong, even PPFD from a slim and lightweight fixture, the XP 4000 is an easy recommendation. The dimmer adds flexibility, letting you run the light anywhere from completely off up to its full 400 watts.
For buyers purchasing through Amazon, make sure to clip the available coupon, because the savings are hefty.
Conclusion
The Bloom Plus XP 4000 pairs authentic LM301H diodes with two Moso drivers, even light distribution, and the lowest heat output of any fixture it replaced. For growers who want strong coverage at 18 inches without heat headaches, it earns a solid recommendation.
Product link
View more details for Bloom Plus XP 4000
This product is mentioned in the review. Check the specifications, options, and compatibility before buying.
View more details for Bloom Plus XP 4000